Load Shedding occurs in South Australia in heatwave conditions

It’s deja-vu all over again in South Australia this evening (Wed 8th February).

Following on from both:
1)  The massive state-wide blackout on 28th September 2016; and
2)  the smaller interruption that occurred on 1st December;
3)  we see load shedding again.

Here’s a quick view of the whole of the NEM through NEM-Watch this evening at 19:30 NEM time (so 20:00 in Adelaide under daylight savings):

2017-02-08-at-19-30-nem-watch-screenshot

That’s not a misprint – it is reading a 1% instantaneous reserve plant margin (or only 26MW of spare capacity declared available for the 19:30 dispatch interval).  That’s ludicrous.

As noted in the snapshot, gas-fired generation is supplying the lion’s share, with the liquid fuelled plants kicking in a bit, and wind doing what it can (albeit in the doldrums on a stinking hot day).  Solar’s also faded into night.  Thankfully, this time, the interconnections have held up.

When are we going to, collectively, stop treating the electricity sector as a political football, or ideologically-driven plaything at both ends of the Emotion-o-meter?

Matthew Warren wrote similarly in the AFR just yesterday.

Surely the South Australian’s deserve better. Politicians, of all flavours, should hang their heads in shame.

Tags: , , , , ,
  • Bookmark and Share

    | More

10 responses to “Load Shedding occurs in South Australia in heatwave conditions”

  1. Ian says:

    Pelican Point 50% mothballed still. That would have saved us this time. Fortunately the load shedding was less than an hour but it is disappointing we have available generation offline due to essentially a market failure in my view. (The most efficient gas generator unable to run economically)

    • David says:

      “The most efficient gas generator unable to run economically”

      You mean the price per kWh wasn’t high enough to turn Pelican Point on ?

    • Suraj Narayan says:

      High efficiency of a combined cycle plant is only useful if the plant runs as a baseload. With high renewable penetration in SA, a combined cycle plant would have to ramp-up and ramp-down to accommodate carbon-free energy from renewables. Such ramping-up/down would not allow a CCGT plant to operate at its most optimum leading to higher operating cost for the owner of the plant. No wonder, a highly efficient CCGT plant is not despatched by the owner in a market with high renewable penetration.
      A reciprocating gas engine power plant is ideally suited for numerous start-stop, ramp-up/down application without impacting the maintenance cost and such a plant can also achieve high efficiency (46~47%). Such a plant can be built in 100MW chunks and allow efficient dispatch of just 10% of its capacity due to its multi-unit configuration.
      I’ll be happy to provide more information.

    • Mark Yates says:

      Hi Ian,

      Quite keen to connect with people with similar interests in this field, would be great to talk further and understand what you do.

      Mark Yates

  2. […] of bandwidth and acres of digital newsprint may well be devoted to arguing the ultimate reasons behind yet another blackout – albeit only partial – in South Australia yesterday […]

  3. Mushalik says:

    Today 9/2/2017 17:00 in South Australia

    Demand 2,824 MW
    Generation 2,765 MW
    Available Generation 2,660 MW
    Imports from Victoria 567 MW

    So SA generation plus imports from Victoria was 3,332 MW much higher than demand

    Why is that? generation plus imports must always be equal to demand. What are the transmission losses?

  4. […] noted on Wednesday, all politicians should be hanging their heads in shame… Tags: high prices, high regional demand, high temperatures, load shedding, New South Wales, […]

  5. […] I posted this quick article late on the day of the load shedding. […]

Leave a Reply

Your email address will not be published. Required fields are marked *